Detailed 3D models and renders for architectural visualizations and product design concepts, plus the things I design for 3D printing and share on MakerWorld.
Parts I designed in CAD and published on MakerWorld.

A pocket-size vertical box with a springless push-button latch. Press the button and the tray slides up out of the shell. Close it and it clicks shut.
View on MakerWorld ↗
This is my first print I made with Creality wooden filament and it turned out pretty good and highly believable. The wood grain texture came from texture mapping I did in Fusion and the feel of the coaster does not feel like plastic at all. To add more realism (between the print bed photo and the cover photo) I sanded it down to make it rougher and I was able to add wood staining to it. I brushed a cherry wood staining on it and it became so much better. I am quite surprised with the results. It was an hour print on my Bambu A1 with all the textures and all but I also ran it at 50% speed which im not sure made a difference in quality or not. It depends from filament to filament but I ended up printing at 200 degrees instead of the default 220. if you feel the print is getting a bit rough with your filament, decrease the temperature.
View on MakerWorld ↗
a smooth, wall key hook. It has 7 pegs. very simple, minimal, clean, and gets the job done. no supports of any kind, a very easy print
View on MakerWorld ↗
This is a simple, triangular desk pen/pencil holder with the additional capability of holding a sticky pad. It has a nice modern look with a mix of ribbed and smooth faces
View on MakerWorld ↗
this is a simple bosch router table dust collector connector I made to fit my dewalt woodworking vacuum. Printed with support.
View on MakerWorld ↗
This is a simple pop on cap that replaces the cap on glass soda bottles after you open them. No supports needed, prints in less than 10 minutes, and works right when you take it of the bed. Very easy to pop on and off. Hugs tightly enough onto the lip of the bottle that it is firmly on yet you can pop it off with some force.
View on MakerWorld ↗
This is a pair of fake earphones designed for you to wear when you need alone time so people will not disturb. It is a less than ten minute print, uses no supports, and uses the silicon ear piece of wired earphones to attach on. If you have any comments, feel free to drop them down below.
View on MakerWorld ↗
This is a headphone stand specifically designed for a headphone and a jawbone headset. It is a two piece install, base and stand which just fit together on first try. No glue necessarily required.
View on MakerWorld ↗Scenes and models I made in Blender.

A detailed 3D model of an Aston Martin sports car, rendered from multiple angles to showcase the exterior body work and design language.

A stylized car model set in a natural outdoor environment, combining vehicle design with detailed terrain and grass rendering.

An architectural visualization of a hotel building across three views, showcasing exterior design, materials, and lighting.

A futuristic hovercar concept model rendered from both front and rear perspectives, exploring sci-fi vehicle design.

An interior design render of a modern living room, exploring lighting, materials, and spatial composition.

A 3D animated backdrop scene rendered in motion, used as an environment asset for other projects.